Guide for student pilots

Crosswind limits for student pilots: how to decide before you take off

Your crosswind limit is the lowest of three figures: the demonstrated crosswind in the aircraft manual, your school’s limit and your own personal limit. Work out the crosswind component for the runway in use, using the gust, and compare it with that limit before you leave the ground.

This guide gives no generic limit, on purpose. The right figure depends on the aircraft, the school and you. Where numbers appear in the examples, they are invented.

1. What the demonstrated crosswind is

The manual of many light aeroplanes gives a “demonstrated” crosswind. It is the strongest crosswind in which the aircraft was flown by a test pilot during certification. It is evidence that the aircraft can handle that wind. It is not a promise that you can, and in many manuals it is information rather than a limitation. Read the wording in your own aircraft’s manual, because manuals differ.

  • The manual sets the ceiling. Do not go above a figure that the manual states as a limitation.
  • Your school usually sets a lower figure for students, and a lower one again for solo flights. It is in the operations manual or the student briefing.
  • You and your instructor may set lower still. A figure you have flown in with the instructor beside you is a different thing from one you will meet alone.

2. The sums

Wind is reported as the direction it blows from, in degrees, and a speed in knots. The crosswind component is the part of the wind that blows across the runway. Take the angle between the wind direction and the runway direction, then:

crosswind = wind speed × sin(angle)
headwind = wind speed × cos(angle)

Without a calculator, use the clock shortcut for the fraction of the wind that is crosswind:

Angle between wind and runwayFraction that is crosswind (sine)Shortcut
15°0.26About a quarter
30°0.50Half
45°0.71About 70 per cent
60°0.87About 90 per cent
90°1.00All of it

Two habits matter more than the arithmetic:

  • Use the gust. If the wind is 12 knots gusting 20, work out the crosswind with 20. The gust is what you will meet in the flare.
  • Use the right north. The wind in a METAR or TAF is a true direction. The wind from the tower or the ATIS is magnetic, like the runway number. Compare like with like, and use the magnetic wind with the runway.

3. A worked example

Runway 27, so the runway direction is 270 degrees magnetic. The tower reports the wind as 330 degrees at 10 knots, gusting 18. Your school’s limit for solo flights is 12 knots. All of these numbers are invented.

  1. The angle between the wind and the runway is 330 − 270 = 60 degrees. The wind is on the right of the runway heading, because 330 is to the right of 270 when you look along the runway.
  2. The steady crosswind is 10 × 0.87 = about 9 knots. With the gust, it is 18 × 0.87 = about 16 knots.
  3. The headwind is 10 × 0.5 = 5 knots steady, or 9 knots in the gust.
  4. The gusting crosswind of 16 knots is above the 12-knot limit. That is a no-go for a solo flight on this runway, and a reason to think about another runway or another day.

4. Check against your limit

Enter the runway and the wind. The result shows the crosswind and headwind or tailwind components and compares the gust crosswind with the limit you enter. For a stand-alone tool with its working shown, use the crosswind component calculator.

Crosswind limit check

5. Deciding before take-off

  1. Know your three figures: the manual, the school and your own. Write down the lowest.
  2. Work out the component for the runway in use, with the gust. Check a second runway if the airfield has one.
  3. Allow a margin. A figure right at your limit leaves no room if the wind picks up. The wind may also be stronger at your destination than at the departure.
  4. Think about the return. If the wind is rising, a flight that is fine now may not be fine when you come back.
  5. Tailwind counts too. A negative headwind component adds to your ground speed and your landing distance. Look at it in the same check.
  6. If in doubt, ask. Put the question to your instructor before the flight, not after.

Crosswind technique is for your instructor to teach in the aircraft. This guide covers only the decision to go or not.

A learning aid only. It does not replace your aircraft’s manual, your school’s limits or your instructor. VectorEFB is not certified for navigation.

Next: the go or no-go weather decision. For the theory, see the lesson on runway surface, slope and crosswind limits. All guides are on the guides page.

VectorEFB opens any airport with its latest METAR and TAF, and keeps your plan for your instructor to review. Request access while it is in private pre-launch.